AstroNova QuickLabel QL-850, Руководство пользователя

Страница: 28 / 127

Getting Started
QL-850 User Guide 28
Unloading Media
1. Press and hold the back-feed key. The printer will back-feed media.
When the media has almost exited the back of the printer, back-feeding will stop and the
printer will beep once. This confirmation tone alerts you that media is about to be
unloaded.
2. To continue and unload media, press and hold the back-feed key again. Media will
back-feed fully out of the printer.
3. Loosen the captive fastener on the outer flange [1]. Then remove the flange from the
mandrel.
4. Turn the wing nut [2] on the end of the mandrel counterclockwise to loosen the mandrel.
Loosen the wing nut until the media roll moves freely.
5. Remove the media roll from the mandrel.
Working with Wide Gap Media
Gap media with wide gaps between labels may require special handling. If the gaps are larger
than 0.125 inches (3.175 mm), observe the following guidelines.
• Before loading media, trim excess liner from the leading edge of the media roll. If the
leading edge has more than 0.125 inches (3.175 mm) of exposed liner material, it may
be difficult to load media properly.
• Adjust the cut/stop position so a leading edge of 0.125 inches (3.175 mm) or less of
exposed liner material results after each print job. Refer to the QL-850 Driver Help for
details.
[1] [2]