External Unwinder
QL-850 User Guide
108
Installing the External Unwinder
Use the following instructions to install the unwinder. Refer to the following illustration during
this process.
1.
Use the
Before Moving
feature in the
Cleaning
tab of the QL-850 Maintenance Utility.
This utility will prepare the printer for lifting and moving onto the brackets. Refer to the
QL-850 Driver Help for details.
2.
Power off the printer. On the rear of the printer, turn the power inlet switch off.
3.
Ensure the power switch on the unwinder [2] is in the off position.
4.
Arrange the brackets [1] as illustrated. Insert the tabs into the corresponding slots on the
brackets.
5.
Align the unwinder [2] with the bracket. Ensure the thumb screw mounting locations align
with the slotted holes on the bracket.
6.
Install the two thumb screws [3] through the bracket slots and into the unwinder [2].
Note: Do not fully tighten the thumb screws at this time. You will tighten the thumb
screws after ensuring proper alignment.
7.
With help from another person, lift the printer and then place it on the brackets.
Caution: The printer is heavy and moving it requires two people. One person should lift
the front by the indicated lift point, while the other person should lift the back by the
indicated lift point. Do not lift the printer by the mandrel. Lift the front of the printer by the
[1]
[2]
[3]
Содержание QuickLabel QL-850
Страница 1: ...U S E R G U I D E...
Страница 127: ...Index QL 850 User Guide 127 W Wing Nut 31...
