background image

off. After the ignition has been turned off, the status LED flashes slowly to indicate that the AED 

will be activated then, the LED flashes normally when AED has been activated.  

Note: For AED to be effective, the Failsafe

®

  

Starter Kill relay must be installed. 

U

NLOCKING

 

Pressing 

 for one second unlocks the doors (if connected). The horn will honk twice (if 

connected) and the parking lights will flash twice to confirm reception of the command. The 

optional Failsafe

®

 Starter Kill will be deactivated. The status LED will turn off. 

Note: If the doors were locked with the remote transmitter, you  

must use the transmitter or the Valet switch to deactivate the starter 

kill. Manually unlocking the vehicle will only unlock the doors. 

D

ISABLING THE 

AED

 WITHOUT A TRANSMITTER

 

If your remote transmitter is lost or damaged, you can manually override the AED. To do this, you 

must have the vehicle's ignition key and know where the Valet

®

 switch is located. Be sure to check 

with the installer for the location of the Valet

®

 switch. 

 

To disable the AED, turn the ignition to the ON position.  

Press and release the Valet switch within 10 seconds. The 

status LED will stop flashing and the vehicle should start.  

If the vehicle does not start, you may have waited too long; 

turn the ignition off and repeat the process. 

 

 

Location of Valet Button____________________________________________________  

S

ILENT MODE

 

To temporarily turn OFF the horn honk(s) confirmations, simply press 

 for less than one second 

before transmitting any commands, the confirmation honk(s) will not be present for that one 

operation only. 

V

ALET MODE

 

You can prevent your system from automatically activating the Failsafe

®

 Starter Kill (optional, not 

included) by using Valet

®

 Mode. This is very useful when washing the vehicle or having it serviced. 

In Valet

®

 Mode, the starter kill cannot be activated, even with the transmitter, but all convenience 

functions (door locks, trunk release, etc.) will continue to work normally. 

© 2006 Astroflex Electronics – All rights reserved 

Содержание VKE-103









Отзывы: