ASTRO SR-8450, Инструкция по эксплуатации, Страница: 41 / 65

Chapter 4 Operation from the remote controller
41
4.6.9 Set the Transition Duration for clips in a playlist
⚫
To set the Transition Duration of a clip stored in a playlist, follow these steps:
1
Follow the instructions in
[4.5.1]
to specify Page, followed by BANK10.
2
Among the
【
F1
】
~
【
F10
】
buttons, the button that has already created a playlist lights up green, so press the button
corresponding to the playlist containing the clip you want to edit the playback speed from among these, and select
the playlist.
3
Press the
【
Loop/PLST
】
button to display the list of clips stored in the playlist.
4
After pressing the 【 Insert / Browse 】 button, operate 【 Jog 】 and move the cursor to the clip you want to edit the
playback speed.
5
After pressing the 【 C 】 button, adjust the playback speed by operating 【 Jog 】 .
6
Press the
【
ENTER
】
button to complete the setting. Press the
【
CLEAR
】
button to cancel it.
・
The maximum setting time is
20 seconds.
・ It does not apply if the Transition Type is Cut.
・ If the setting value of Transition Duration is an error, it is displayed in red after setting is completed. For details
, see the note "About Transition Duration Error" below.
 About Transition Duration Error
Transition Duration will be an error if it is set to the following setting. If you play with the error, playlist is
played with the
Transition Type is Cut.
⚫ When the setting time of the Mix is longer than the playback time of the clip being set or the previous clip
⚫ If the Fade To Color setting time is longer than the playback time of the previous clip
⚫ If the Fade From Color setting time is longer than the duration of the clip you are setting
⚫ Fade To/From Color is half the duration of the setting clip or the previous clip
⚫ Mix, Fade To Color, Fade From Color, or Fade To/From Color are overlapped each other