www.Astria.US.com
13
126758-01A
MOSAIC™ AND ESTATE™ REFRACTORY PANELS
KIT CONTENTS
•
(1) ea. Left Side Refractory Panel.
•
(1) ea. Right Side Refractory Panel.
•
(1) ea. Back Refractory Panel.
•
(1) ea. Bottom Refractory Panel.
•
(1) ea. Bottom Center Refractory Panel.
The following items, required for this installation, are included in this kit:
(2) ea. Upper Corner brackets
(2) ea. Grate retainer
GENERAL INFORMATION
This kit contains five refractory panels (two sides, one back, one bottom, one bottom
center) and installation instructions for their installation.
IMPORTANT: Installation of brick panels should be
done after the fireplace is placed in a permanent
location.
Note:
Remove grate, screen assemblies and all hardware components
out of the box prior to installation.
INSTALLATION
1.
Install bottom brick panel. Using at least two people, hold bottom brick panel
by its side edges. Place the back edge of bottom panel into the firebox first and
carefully lower the front edge of panel. Make sure bottom panel is centered
in the firebox and flush with the front of the fireplace. Be careful not to pinch
your fingers between the panel and firebox.
2.
Position "Z" shape retaining brackets on top of the notched area toward the
rear of the bottom brick panel. Grate retaining bracket should be positioned
as shown in Figure 21.
WARNING
LIFTING HAZARD
SINGLE -PERSON LIFT COULD
CAUSE INJURY.
USE ASSISTANCE WHEN MOVING
OR LIFTING.
Figure 22 - Installing Refractory Panels
LEFT BRICK
PANEL
PANEL
RIGHT BRICK
REAR BRICK
PANEL
BOTTOM
BRICK PANEL
GRATE
GRATE RETAINER
ASH PANEL
BRACKET (2x)
UPPER CORNER
BRACKET (2x)
Figure 21 - Installing Grate Retainers
INSTALLER NOTICE:
•
READ ALL THESE STEPS BEFORE STARTING THE INSTALLATION.
•
THESE INSTRUCTIONS MUST BE LEFT WITH THE APPLIANCE.
•
ALL WARNINGS, PRECAUTIONS, AND INSTRUCTIONS IN THE
INSTALLATION INSTRUCTIONS PROVIDED WITH THE APPLIANCE
ALSO APPLY TO THESE INSTRUCTIONS.
•
IF YOU ENCOUNTER ANY PROBLEMS, NEED CLARIFICATION OF
THESE INSTRUCTIONS, OR ARE NOT QUALIFIED TO PROPERLY
INSTALL THIS KIT, CONTACT YOUR LOCAL DISTRIBUTOR OR
DEALER.
3.
Install rear brick panel. This panel has a top and bottom side. To determine cor
-
rect position, match up the pattern on the rear panel with the right and left brick
panels before installing. Make sure rear panel is centered before continuing.
4.
Install the right and left brick panels with the gas line knock outs placed down
toward the bottom refractory. Align the right an left brick panels with the rear
panel so the grout lines line up.
5.
Install upper corner brackets and tighten set screws (see Figure 22).
6.
Install grate by placing rear legs into slots in the grate retainer (see Figure 22).