figure 14
In some models you have the arm with locking system. To rotate the arms, pull the handle until the me-
chanism is disengaged and turned to the desired position, then release the handle making sure that the
mechanism engages again as its showed in “Figure 14”.
5.7 Secure the working area
Once the elevator is correctly positioned, the following guidelines should be followed:
. Verify that the safety zone is free of people, objects or obstacles before and during the process of raising
or lowering the vehicle, which has already been mentioned in this manual. Continue the operation only if
everything is stable and there is no danger.
Apuana S.L. is not responsible for civil or criminal matters or for any injury that may occur if
the aforementioned indications are not respected.
WARNING
5.8 Movement of the lift with load
Thanks to the accessories, it is possible to move the lift with the vehicle on the top without hardly any
effort on the entire surface of the workshop. For this, it is essential to have a double effect cylinder system.
In order to move the lift with the vehicle on the top, the vehicle must exceed the height of 35 centimeters.
This is the moment to place the accessories in their corresponding guides and secure them with the pin,
as indicated in figure 15.
Once this has been done on the four support points, it is necessary to turn the handle in the DOWN position
and operate the pedal to raise the legs from the ground while the wheels of the accessories make contact
with the ground holding all the weight. It is sufficient to raise the legs of the soil about 10 cm approximately
16
USER MANUAL
·
AE5000 powerLIFT / AE500R powerLIFT & move
