11
SYSTEM SETUP
USB Interface Connection -
Connect the USB Type A connector side of the
Handpiece Cable to any available USB 2 .0 High Speed, high power port on
the user supplied Computer System . Always make sure to use the same USB
port whenever re-connection of the USB cable is necessary .
USB Interface Connection
USB Type A
Connector
Important:
Use a High Power (500 mA) USB 2.0 Port Only
Handpiece
Cable
Computer
USB 2.0
Port
Handpiece Holder with Chair-side Adapter -
Installing the Chair-side
Adapter is as easy as deciding on a location for maximum convenience
and securing it to an empty customer-supplied standard Handpiece Holder .
Refer to the illustration below and install the Chair-side Adapter as follows:
1 . Insert Handpiece Holder Adapter
(1) into the wide end of Grip (2) .
2 . Press Grip (2) into the top of the
chosen Handpiece Holder .
3 . Insert Expander (3) into the bot-
tom of Grip (2)
4 . Insert and push the Joint Connector
Hex Bolt (4) into Expander (3)
engaging the thread of Handpiece
Holder Adapter (1) by turning the
Joint Connector Hex Bolt (4) clock-
wise .
5 . Using the supplied Short Arm Allen
Wrench (5), tighten Joint Connector
Hex Bolt (4) until the Chair-side
Adapter is secure in the Handpiece
Holder .
Handpiece Holder Chair-side Adapter
Assembly
5
1
3
4
Customer-Supplied
Handpiece Holder and
Hanger Bar
2
1
Handpiece Holder Adapter
2
Grip
3
Expander
4
Joint Connector Hex Bolt
5
5/32 Short Arm Allen
Wrench
