AT200 Installation Guide
1.
Check that the back-up battery is fitted and plugged-in
a.
insert a SIM, the device should power-up, as indicated by the LEDs on each side of the
connector:
push SIM all the way in
noting the position of the cut-out corner
…and check that LEDs light
2.
If LEDs do not light-up, unclip the AT200 enclosure, remove the PCB assembly
and check that the battery is plugged into the PCB connector:
check that battery is plugged in here
a.
Do not attempt to remove the battery from the cover, once it has been stuck down,
as prising or bending could cause fire and smoke.
