Aston Global ATC-T5, Инструкция по установке, эксплуатации и обслуживанию

Страница: 23 / 29

Aston Technologies Inc. www.astontechusa.com
21
Maintenance, storage, and scrap
5.1
Maintenance
5.1.1
Maintenance
◇ Prohibit unauthorized personnel for maintenance operation. To extend the service life of
the tire changer, maintenance should be performed according to the requirements of the
manual. If the machine is not maintained regularly, the operation and reliability cannot
be guaranteed, and even cause danger to the operator or the people in the vicinity of the
machine. The manufacture will not be responsible for the accidents or results caused
by lack of regularly maintenance. Before any maintenance operation, circuit and gas
supply device must be disconnected ,turn off the switch. In order to release the pressure
of the air from the line, it is necessary to press the pedal 3-4 times.
◇ It must be professional staff to use the original spare parts do the timely replacement of
damaged parts. The safety device (safety valve, control valve) of the unauthorized
removal or replacement is a violation of state regulations on work safety. (
Note: the
manufacturer is not responsible for damage caused by the parts of other manufacturer
and the damage caused by the disassembling of the safety device).
5.1.2 Tending
◇ Regular use of diesel oil to clean Center Spindle to prevent the formation of dirt. Coat
fixing clamps rail with lubricant oil.
◇ As shown in Picture 15-A, control oil mist level in the Oil Drier. If the oil level is lower,
you need to unscrew the Oil Drier cover F, and then as figure 15-A, add some oil. HG
ISO and viscosity of VG32 ISO type oil mist is recommended.(like ESSO Febis
K32
，
MOBIL Vacouline 1405
，
KLUBER32). When stepping the pedal 3 to 4 times,
check whether there are oil drops into the oil cup F, if not, adjust screw D.
◇
As shown in Picture 15-C, machine motor is not powerful enough, adjust the triangle
belt of the motor by the following steps: (before any operation, cut off the power)First,
Unscrew the 4 screws on the side of the box, remove the left side protective plate of the
tire changer. Second, use special adjustment screw X (Figure 15-C) that is in the motor
support base to adjust the triangle belt.
17