ASTi Telestra Target Operations & Maintenance Manual (Ver. 2, Rev. M)
Copyright © 2020 Advanced Simulation Technology inc.
11
3.4. Default Network Settings
After initial software installation or system cold start, the Target Ethernet interface
eth0
tries to
obtain a network IP address and subnet mask using DHCP. To obtain these network settings, a
DHCP server must exist on the network intended for use by
eth0
. If the Target cannot contact a
DHCP server using
eth0
, it will assign a meaningless IP address of 0.0.0.0 to that interface.
The Target’s other two Ethernet interfaces,
eth1
and
eth2
, are assigned default IP addresses and
subnet masks. Refer to the figure under “Network Ports” for the physical locations of the Ethernet
ports.
If you do not wish to use DHCP to configure
eth0
(or if the network does not have a DHCP
server), the user must manually configure the network configurations including the IP address,
subnet mask, and gateway IP. Ask your network administrator for valid IP address and subnet
masks for the network(s) where the Target will be integrated.
Note
: Manually setting the network configuration requires that a keyboard and monitor be
connected directly to the Target.
To manually set the network configuration, log in to the Target as:
Login: root Password: abcd1234
Then type the following:
ace-net-config -a xxx.xxx.xxx.xxx -n yyy.yyy.yyy.yyy
where
xxx.xxx.xxx.xxx
is the IP address and
yyy.yyy.yyy.yyy
is the netmask.
After manually configuring interface
eth0
(if not using DHCP), users must use the
RMS web
interface to change settings for the Target’s Ethernet ports. For more information on
the
RMS,
reference the
Telestra
Remote Management System User Guide.
