23
Three parameters must be set in this panel:
Output which is to be affected by a signal at the driver input (selectable from A, B, C, AB, AC, BC or ABC).
Switch-on delay – this is the time from the moment the signal appears at the driver input, after which the
selected output will be switched on.
Switch-off delay – this is the time from the moment the signal at the driver input disappears, after which the
selected outputs will be switched off.
After entering all parameters, press the "Set" button in order to confirm the changes.
CAUTION!!! - If the input operates in the "Cascade" mode, the selected outputs are not subject to any other outputs.
rule of control, e.g. switching ranges.
5.8
Service switching
Service switch-on seen as the ASTmidi driver is a demanded switch-on of a selected output A, B or C.
The ASTmidi / ASTmidi GPS drivler is equipped with two relay outputs with a NO contact. Outputs A, B and C are
programmable independently and can be in one of four states:
AUTO – the output works automatically according to the set of switch-on and switch-off intervals for each day
of the week.
OFF – the output is permanently switched off, it is not subject to any control rules.
ON – the output is switched on permanently, it is not subject to any control rules.
