49
ASSA ABLOY Hospitality
66 1100 005-11
8. Troubleshooting and maintenance
8.1 To reset the main control unit
If there are problems with some Allure functions after connecting/disconnecting
components or after uploading firmware to the LCU, make a reset of the
main control unit.
Figure 76
3. Press the small button which is located beneath
the LCU; see reset button marked in Figure 76.
Note:
There are two buttons; the reset button
is the one which is located closest to the LCU.
8.2 To remove an access panel
Figure 77
1. Present a valid staff card at the access panel.
2. Open the locking mechanism on the back frame
for the access panel; see Figure 77.
3. Remove the access panel from the back frame.
4. Perform the needed maintenance.
Figure 78
5. Snap the access panel onto the back frame again
and push down the locking mechanism according
to Figure 78.
6. Present a valid staff card at the access panel and
make sure that the door opens.
