Assa Abloy TRAKA32, Руководство пользователя

Страница: 729 / 919

V3.5 14/08/19 UD0089 Page 729
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
4.6 16BIT CONFIGURATION MENU
The Configuration Menu of the 16bit Traka System allows you to configure certain settings, such as reset the system,
change the CPSN number and restore the Default Configuration.
1. Using the Master Key, unlock the CAM Lock. The Control Panel is hooked in at the bottom and locked at
the top. Carefully begin to open the Control Panel.
2. Hold down the
#
key on the keypad. At the same time press and release the Reset button on the 16bit
Control PCB .
3. Close the Control Panel carefully into the Pod and lock with the Master Key. The Control Panel should fit
easily, if not check that no wires have become caught or trapped between the Control Panel and the Pod.
4. The LCD will now be displaying the following, at this point you will need to enter the last 4 digits of the
cabinet/system serial number and press
#
. For example if the cabinet serial number was TKC12345 you will
need to enter 2345 then press the
#
key.
After entering your PIN the LCD Configuration menu will appear. There are two main options to the configuration
menu, System and Utilities.
System
Press the 1 key from the main configuration menu to enter the System menu. From here you can alter the Serial
Number, change the CPSN Number or edit the communication of the selected cabinet. Because there are four options
to the system menu, you will need to use the # key to scroll down to select the other two options.
Serial Number
Press 1 at the System menu to enter the Serial Number section. To change the Serial Number press the
*
key to delete the current number and enter the appropriate number via the Traka keypad and press #.
CPSN
Press 2 at the System menu to enter the CPSN section. To change the CPSN Number press the
*
key to
delete the current number and enter the appropriate number via the Traka keypad and press #.