V2.4 03/08/18
TD0068
Page 8 of 38
This Document is uncontrolled when printed unless over stamped “CONTROLLED DOCUMENT”
4.
EXTENSION SYSTEMS OVERVIEW
If your system does not have extension cabinets you can skip this section.
Additional ‘extension’ cabinets are installed alongside the main system. Up to three additional extensions can be added
for a total of four systems.
NOTE:
Each extension cabinet will be clearly marked to indicate which order they should be located next to
the main system. It is important that the cabinets are located in this order as all DIP switch address
configuration and position numbering will already have been carried out at Traka during test.
Each system will be linked together via a receptor cable that connects to the CAN Interface PCB. The CAN Interface PCB
is secured to the back of the blank fascia at the top of each cabinet.
