25
A7690C • 800-810-WIRE (9473) • www.sargentlock.com
4/15/08
Copyright
©
2008 SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is pr
ohibited.
1. Apply power to the System
2. Green LED on Electroguard™ insert will illuminate
3. Horn will sound for one second
4. Rail assembly is armed. Latchbolt cannot be retracted by
depressing the push rail for immediate egress
5. If any of above sequence fails to function, the unit is not armed.
See: Trouble Shooting
1. Rotate key clockwise and return key to center position (remove key)
2. Red LED flashes on insert for a factory preset time of 5 seconds.
(For other time selections, see Dip Switch Settings Section on
page 6.) The rail assembly will disarm itself for this time period allowing
for momentary egress
3. After the factory preset time of 5 seconds, delay expires. Rail
assembly re-arms itself
4. Unit is then in Delayed Egress Mode or Power Up State
1. Rotate key counter-clockwise and return key to center position
(remove key)
2. Red LED will illuminate
3. Rail assembly is disarmed allowing the device to operate as a
standard exit device permitting free egress
1. Rotate key clockwise and return key to center position (remove key)
2. Red LED de-energizes and Green LED will illuminate
3. The rail assembly re-arms itself into the Delayed Egress Mode
There are three modes of operation: Delayed Egress, Momentary Egress, and Maintained
Egress. If operating a BC-59-80 Series device, a door status switch (3287) is required.
Delayed Egress Mode
A
B
C
Momentary Egress Mode
A
B
C
Maintained Egress Mode
A
B
C
Resetting the Unit from Maintained Egress Mode
to Delayed Egress Mode
A
B
C
Red LED
Green LED
Operating Instructions
15
A7690C.indd 25
11/8/18 9:02 AM
