1431 DOOR CLOSER WITH P10/PH10 ARM
INSTALLATION INSTRUCTIONS
CAUTION: FAILURE TO INSTALL OR ADJUST PROPERLY
MAY RESULT IN INJURY OR DAMAGE.
FOR ASSISTANCE, CALL SARGENT AT 1-800-727-5477
1
LOCATE AND MARK HOLES USING FULL SIZE TEMPLATE OR
MEASURE AS SHOWN BELOW
RIGHT HAND SHOWN, LEFT HAND OPPOSITE.
PULL SIDE PULL SIDE
PUSH SIDE PUSH SIDE
LEFT HAND DOOR RIGHT HAND DOOR
1431 CLOSER AND P10 ARM ARE NON-HANDED
ONLY THE PH10 ARM IS HANDED
ATTACH FOOT BRACKET TO DOOR STOP.
3
4
ATTACH DOOR CLOSER TO DOOR WITH SPRING POWER NUT
TOWARD HINGE.
PRE-DRILL 3/32" HOLES FOR SELF TAPPING
SCREWS OR USE #16 DRILL (DIA.177) AND
TAP #12-24 FOR MACHINE SCREWS
A7387D
1
* NOTE: FOR MAXIMUM POWER, INSTALL FOR 90° OPENING.
ALTERNATE: PREASSEMBLE ARM PRIOR TO
ATTACHING TO STOP
4A
+
or
USE FIFTH HOLE SPACER
WHEN REQUIRED
IMPORTANT: USE A MINIMUM OF 5 SCREWS
HAND
(PH10 ONLY)
2
Copyright © 2006-2008 SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
A7387C 1/30/08 3:17 PM Page 1
