Rixson® and Smok-Chek® are registered trademarks of Yale Security Inc., an ASSA ABLOY Group company.
Copyright© 2003, 2009, Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc., is prohibited.
4. Making Adjustments to the Holder
A. Closer spring force should be as low as possible.
(Closer should arrive at lowest setting).
B. Turn
OFF
Power (using ON/OFF switch).
C. To set Hold Open:
1.
Door should be in
CLOSED
position.
2.
Raise or lower cam until the word “Push” is dis-
played from the
UNDERSIDE
of the unit (Fig 4a).
3.
Open door to desired Hold Open position.
4.
Raise or lower cam and
ROTATE
until pocket of
cam is in position next to Roller A shown in Fig 4b
5.
Release cam to re-engage teeth.
6.
Turn
ON
power (using ON/OFF switch).
7.
OPEN DOOR.
Door should stay in Hold Open
position–if not, repeat Steps 3 and 4.
8.
Pull door
OUT
of Hold Open–door should close
freely.
9.
OPEN DOOR
. If releasing force needs to be
increased, turn adjusting nut
IN.
If lesser holding
force is desired, turn nut
OUT
.
10.
Attach holder cover.
Trouble-Shooting Tips:
1.
Turn ON power.
2.
Can door swing far enough to engage hold open? Minimum opening is 85°.
3.
Make sure closer is at lowest spring setting.
4.
Put piece of metal against the magnet to make sure it is receiving current.
5.
If not, double check wiring instructions.
6.
If so, with door in closed position look up at holder mechanism. Word PUSH should be visible, if
not, adjust cam.
7.
Turn adjusting nut.
8.
Check arm indexing.
Page 4
ISFM0101
Fig 4a
Fig 4b
Hold Open
Adjust Nut
www.rixson.com
Push Side Mounting
ASSA ABLOY
RIXSON
®