Copyright © 2017 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
80-9363-0001-020 Rev 7 08/17
Page 10
Set Application
10
A. Determine if unit is Push or Pull. If Push
application, the door opens away from you. If
Pull application, the door opens toward you.
B. Flip the PUSH/PULL ARM dip switch to OFF for
a Push application or ON for a Pull application.
See Illustration at right.
Set Door Open and Closed Position
11
A. To set the closed position, fully close the door.
Press and release the CLOSE button on the
board (see Illustration at right). The flashing
ORANGE LED should turn solid.
NOTE:
Any
time the door is in the closed position, the
orange LED should be solid.
B. The GREEN OPEN LED should now be
flashing. To set the fully open position, manually
open the door to the open position and hold the
door there.
NOTE:
If there is a wall or door stop
at the open position, do not hold the door
against the wall or stop.
Press and release the OPEN button on the
board (see illustration at right). The flashing
GREEN OPEN LED should turn solid.
NOTE:
Any time the door is in the open position, the
green LED should be solid.
If the open
position is not set within 30 seconds of
setting the closed position in Step 11A, then
Step 11 must be repeated.
C. Once door has fully closed after Step 11B,
make sure there are no obstructions that could
prevent the door from opening. Latching
hardware must not prevent the door from
opening during the following step.
D. The operator must now learn its internal
settings. Press and release the LEARN button
on the board (see illustration at right). The
BLUE LEARN LED will start flashing and the
door will open in small increments. Allow the
door to open and close without interference.
NOTE:
If the spring is adjusted or accessories
are attached to the door that would make the
door heavier,
Step 11D MUST be repeated
.
LEARN
button
CLOSE
button
OPEN
button
OFF ON