ASROCK Z170 PRO4/D3, Руководство пользователя

Страница: 23 / 142

21
English
Z170 Pro4/D3
USB 3.0 Header
(19-pin USB3_4_5)
(see p.1, No. 7)
1
Dummy
GND
GND
Vbus
GND
GND
IntA_
Vbus
In
IntA_PA_D-
IntA_
IntA_PA_SSTX-
IntA_PA_SSRX-
IntA_PB_SSRX-
IntA_
IntA_PB_SSTX-
IntA_P
IntA_PB_D-
In
Besides four USB 3.0
ports on the I/O panel,
there is one header on this
motherboard. Each USB
3.0 header can support
two ports.
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, No. 21)
J_SENSE
OUT2_L
1
MIC_RET
PRESENCE#
GND
OUT2_R
MIC2_R
MIC2_L
OUT_RET
his header is for
connecting audio devices
to the front audio panel.
Chassis Fan Connectors
(4-pin CHA_FAN1)
(see p.1, No. 9)
(3-pin CHA_FAN2)
(see p.1, No. 3)
GND
FAN_VOLTAGE
CHA_FAN_SPEED
FAN_SPEED_CONTROL
GND
FAN_VOLTAGE
CHA_FAN_SPEED
Please connect fan cables
to the fan connector and
match the black wire to
the ground pin.
1. High Deinition Audio supports Jack Sensing, but the panel wire on the chassis must sup-
port HDA to function correctly. Please follow the instructions in our manual and chassis
manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by the
steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to connect
them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel and
adjust “Recording Volume”.