29
ASRock P67 Extreme4 Gen3 Motherboard
the red-striped side to Pin1
2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.2 No. 33)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Serial ATAII Connectors
These four Serial ATAII (SATAII)
(SATA2_2: see p.2, No. 15)
connectors support SATA data
(SATA2_3: see p.2, No. 16)
cables for internal storage
(SATA2_4: see p.2, No. 17)
devices. The current SATAII
(SATA2_5: see p.2, No. 18)
interface allows up to 3.0 Gb/s
data transfer rate.
Serial ATA3 Connectors
These four Serial ATA3 (SATA3)
(SATA3_0: see p.2, No. 13)
connectors support SATA data
(SATA3_1: see p.2, No. 14)
cables for internal storage
(SATA3_M1: see p.2, No. 11)
devices. The current SATA3
(SATA3_M2: see p.2, No. 12)
interface allows up to 6.0 Gb/s
data transfer rate. If you install
the HDD on the eSATA port on
the rear I/O, the internal
SATA3_M2 will not function.
SA
TA2_4 SA
TA2_2
SA
TA2_5 SA
TA2_3
SA
TA3_0 SA
TA3_M1
SA
TA3_1 SA
TA3_M2
Serial ATA (SATA)
Either end of the SATA data
Data Cable
cable can be connected to the
(Optional)
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
connect to the SATA
HDD power connector
connect to the
power supply
Serial ATA (SATA)
Please connect the black end
Power Cable
of SATA power cable to the
(Optional)
power connector on each drive.
Then connect the white end of
SATA power cable to the power
connector of the power supply.
English
