ASROCK P45XE, Руководство по установке, Страница: 30 / 194

3 0 3 0
3 0 3 0 3 0
ASRock P45XE-WiFiN / P45XE-R / P45XE Motherboard
EnglishEnglishEnglishEnglishEnglish
2.9 eSA 2.9 eSA
2.9 eSA 2.9 eSA 2.9 eSATTTTTAII Inter
AII Inter
AII Inter AII Inter AII Interface Introduction
face Introduction
face Introduction face Introduction face Introduction
C
B
A
HDMI_SPDIF Header HDMI_SPDIF header, providing
(3-pin HDMI_SPDIF1)
SPDIF audio output to HDMI VGA
(see p.2 No. 28 or p.3 No. 27)
card, allows the system to
con nect HDMI Digital TV/
projector/LCD devices. Please
connect the HDMI_SPDIF
connector of HDMI VGA card to
this header.
HDMI_SPDIF Cable Please connect the black end (A)
(Optional)
of HDMI_SPDIF cable to the
HDMI_SPDIF header on the
motherboard. Then connect the
white end (B or C) of
HDMI_SPDIF cable to the
HDMI_SPDIF connector of HDMI
VGA card.
A. black end B. white end (2-pin) C. white end (3-pin)
eSATAII connectors
(eSATAII_TOP (Port 4) and
eSATAII_BOTTOM (Port 5))
NOTE:
1. If you set “Configure SATAII as” option in BIOS setup to AHCI or RAID mode, Hot
Plug function is supported with eSATAII devices. Therefore, you can insert or
remove your eSATAII devices to the eSATAII ports while the system is power-on and
in working condition.
2. If you set “Configure SATAII as” option in BIOS setup to IDE mode, Hot Plug function
is not supported with eSATAII devices. If you still want to use eSATAII function in IDE
mode, please insert or remove your eSATAII devices to the eSATAII ports only when
the system is power-off.
3. Please refer to page 32 to 33 for detailed information of RAID mode, IDE mode, and
AHCI mode.
How to install eSATAII?
SATAII connectors (SATAII_5 (Port 4)
and SATAII_6 (Port 5))