ASROCK N68-VGS3 UCC -, Руководство пользователя

Страница: 17 / 146

1 7 1 7 1 7 1 7 1 7
ASRock N68-VGS3 UCC / N68-VS3 UCC Motherboard
connect the blue end
to the motherboard
EnglishEnglishEnglishEnglishEnglish
after you update the BIOS. If you need to clear the CMOS when you just finish
updating the BIOS, you must boot up the system first, and then shut it down
before you do the clear-CMOS action.
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 6)
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors These four Serial ATAII (SATAII)
(SATAII_1 (PORT 0.0):
connectors support SATAII
see p.2, No. 12)
or SATA hard disk for internal
(SATAII_2 (PORT 0.1):
storage devices. The current
see p.2, No. 9)
SATAII interface allows up to
(SATAII_3 (PORT 1.0):
3.0 Gb/s data transfer rate.
see p.2, No. 11)
(SATAII_4 (PORT 1.1):
see p.2, No. 10)
Serial ATA (SATA) Either end of the SATA data cable
Data Cable can be connected to the SATA /
(Optional)
SATAII hard disk or the SATAII
connector on the motherboard.
SA
T
AII_1 SA
T
AII_2
(PORT 0.0) (PORT 0.1) SA
T
AII_3 SA
T
AII_4
(PORT 1.0) (PORT 1.1)
connect the black end
to the IDE devices
80-conductor ATA 66/100/133 cable