ASROCK Fatal1ty FM2A88X Plus Killer, Руководство пользователя

Страница: 28 / 192

24 25
English
Power LED Header Please connect the chassis
(3-pin PLED1)
power LED to this header to
(see p.1 No. 18)
indicate system power status.
The LED is on when the system
is operating. The LED keeps
blinking in S1 state. The LED is
off in S3/S4 state or S5 state
(power off).
Chassis Speaker Header Please connect the chassis
(4-pin SPEAKER 1)
speaker to this header.
(see p.1 No. 16)
1
+5V
DUMMY
DUMMY
SPEAKER
PLED (System Power LED):
Connect to the power status indicator on the chassis front panel. The
LED is on when the system is operating. The LED keeps blinking
when the sys-tem is in S1 sleep state. The LED is off when the system
is in S3/S4 sleep state or powered off (S5).
HDLED (Hard Drive Activity LED):
Connect to the hard drive activity LED on the chassis front panel. The
LED is on when the hard drive is reading or writing data.
The front panel design may differ by chassis. A front panel module
mainly consists of power switch, reset switch, power LED, hard drive
activity LED, speaker and etc. When connecting your chassis front
panel module to this header, make sure the wire assignments and the
pin assign-ments are matched correctly.
Chassis and Power Fan Please connect the fan cable
Connectors to the fan connector and
(4-pin CHA_FAN1)
match the black wire to the
(see p.1 No. 17)
ground pin.
(4-pin CHA_FAN2)
(see p.1 No. 15)
(4-pin CHA_FAN3)
(see p.1 No. 9)
(3-pin PWR_FAN1)
(see p.1 No. 2)
1
PLED+
PLED+
PLED-
GND
+12V
CHA_FAN_SPEED
FAN_SPEED_CONTROL
GND
FAN_VOLTAGE
CHA_FAN_SPEED