Assembly
1. Prepare the Assembled Base.
You need:
8x Bolts (60mm), 8x Barrel Nuts, an Allen Key and possibly a Screwdriver
NOTE: Please refer to the orientation option images on the back page of this user guide to help
you understand how the product is constructed. This guide only shows construction with the
Ladder positioned on the Right (Option A). For option B the Mattress Rails must be switched
around so that the Ladder will be positioned on the Left.
With a minimum of two people attach the mattress rails to the ends using 8x bolts (60mm) and 8x barrel
nuts. Fully support the parts and insert each bolt through the hole in the bed end into the hole in the end
of the mattress rail and then finally engaging into the hole in the side of the barrel nut (see Fig 1.1).
Once each bolt is engaged, tighten with an allen key. You may find this process easier if a screwdriver
is used to align the barrel nut holes (Fig 1.2).
Note: Do not fully tighten the bolts yet, this will make
it
easier to fit the guard rails later in stages 2,5 & 6.
Fig 1.1
Fig 1.2
2. Fit the Rear Guard Rail.
You need:
2x Bolts (60mm), 4x Dowels and an Allen key.
Once the ends and mattress rails are secure, carefully fit the rear guard rail. Insert 4x dowels
into the large holes in the ends of the guard rail (Fig 2.1). Once the dowels are fitted, carefully
lift the rail into position aligning and engaging the dowels into the corresponding holes in the
bed ends. Once all is aligned correctly, secure the guard rail in position using 1x Bolt (60mm)
at each rail end (Fig2.2).
Fig 2.1
Fig 2.2
3. Assemble the Ladder.
You need:
4x Bolts (35mm) and an Allen Key.
Note:
The ladder must be constructed to suit the left or right hand of the bed. The ladder
construction shown below only applies for positioning the ladder on the right (orientation
option A). For left hand ladder construction, simply swap the legs over (opposite to what is
shown below). Once you have decided which end the ladder is required, align the holes in the
ladder legs with the holes in the treads. Secure the parts together by inserting the 4x bolts
(35mm) into the holes and tightening each one with an allen key.
4. Attach the Ladder.
You need:
2x Bolts (35mm), 1x Bolt (60mm) and an Allen Key.
Secure the ladder to the assembly using 2x bolts (35mm) for the mattress rail
attachment (Fig 4.1) and 1x bolt (60mm) for the leg attachment (Fig 4.2).
Fig 4.1
3
Fig 4.2
4
