ASL INTERCOM RPA01, Руководство по эксплуатации продукта

Страница: 12 / 20

RPA01 - Product Manual
U-0618-0086.doc – Issue: 04 complete, approved
Page 12 of 20
3 Maintenance
3.1 Charging the Battery
A new battery must be charged for at least 2 hours before being used for the first time. It reaches its
optimum capacity after a few cycles of use.
A fully charged battery should last up to 7 hours of continuous talk time, which translates to several days of
normal operational use. However it is recommended that the RPA01 transmitter is returned to its charging
bay on a daily basis to completely eliminate the risk of the batteries running flat when the unit is in service.
The rechargeable battery built into the RPA01 transmitter is of Lithium Polymer composition and thus can
be recharged without being fully discharged. However, they will benefit from an occasional complete
discharge.
!
!
•
The battery must be charged in-situ using the RCS01 Charging Station, which can be
separately ordered. Typically it takes 2 hours to recharge a flat battery. Please, refer to
the RCS01 Charging Station Product Manual for further details [Table 1, page 18].
•
Keep battery charging contacts clean, by wiping them with a soft cloth.
3.2 Cleaning the Microphone
Clean the exterior surfaces with a cloth that has been slightly moistened with water. A mild detergent
solution may be used. Be sure to wipe away any detergent residue with a clean water-dampened cloth.
After a long period of use the microphone grille may become blocked with dust and debris, leading to
reduced audio quality. If the grille cannot be easily cleaned, then the RPA01 should be returned to a service
agent for cleaning.
! !
Do not immerse the RPA01 transmitter in water or other liquid.