ASL INTERCOM MPS Series, Руководство по настройке, Страница: 15 / 60

MPS-Series – Configuration Guide
U-0664-0265.doc – Issue: 03 complete, approved
Page 15 of 60
Table 3 Configuration file attributes
MPS Microphone Software Version 1.5.13
Attributes Description Attribute Values
globals config-version version Configuration version As required.
mcast-address ipaddr Mulitcast address “239.1.0.1” (Do not change!)
LCD Display: IP SETTINGS>CTL IP ADDRESS
NOTE: The microphone will not operate in
fallback mode (LOCAL CONTROL) if this
address is modified.
port Multicast port “15256” (Do not change!)
LCD Display: IP SETTINGS>CTL IP PORT
trace-address ipaddr IP address for the Trace
application (for ASL use) As supplied (Do not change!)
port Communication port (for ASL
use) "1501" (Do not change!)
config-address ipaddr IP address of the PC hosting
the Config Tool As required
NOTE: The host PC must be in the same subnet
as the microphone.
port Communication port "1502" (Do not change!)
host-address ipaddr Host multicast address “239.1.0.1” (Do not change!)
NOTE: The Configuration Tool may not be able
to communicate with the microphone if this
address is modified.
port Communication port "15256" (Do not change!)
default-routing-
params
reserve-timeout Route reserve timeout "1000" (Do not change!)
make-timeout Make route timeout "1000" (Do not change!)
release-timeout Release route timeout "1000" (Do not change!)
hold-timeout Hold route timeout "5000" (Do not change!)
alarm-to Alarm timeout "3000" (Do not change!)
reserve-retries Route reserve retries "2" (Do not change!)
release-retries Route release retries "2" (Do not change!)
status-timeout Status timeout "5000" (Do not change!)
chime-delay Fallback mode: time interval
required between TTT press
and Speak Now indication for
chime playback "4000" (as required)
default-audio-
params
op-gain-
headphone Auxiliary audio output (3.5 mm
jack) gain “0” (maximum level – 100%) to “120” (minimum
level – 0%)
Default: “0” (100%)
LCD display: AUDIO LEVELS>HEADPHONE
op-gain-router Audio output gain (to Router) “0” (Do not change!)
op-gain-
speaker Built-in speaker output gain “0” (maximum level – 100%) to “120” (minimum
level – 0%)
Default: “0” (100%)
LCD display: AUDIO LEVELS>SPEAKER
op-gain-expand Audio output gain (expansion
module, for future
development) “0” (Do not change!)
ip-gain-bgm Auxiliary audio input (3.5 mm
jack) gain “0” (minimum level – 0%) to “120” (maximum
level – 100%)
Default: “90” (75%)
LCD display: AUDIO LEVELS>MUSIC IP