Transport protection for the door
Do not forget to remove the transport protection for the door when unpacking the dishwasher.
Placing the dishwasher
The dishwasher can be installed built-in, completely freestanding or partially built-in. Make sure the
area on which the dishwasher is to be installed is firm.
A. Built-in
The dishwasher is intended to be built-in under a worktop. The installation dimensions are shown in
the illustration. The cable and hose hole (for inlet and outlet hoses and for the power cable) does
not need to be bigger than 38 mm in diameter. Ensure that the edges of the hole are smooth and
cannot cause damage to the hoses or power cable. If the dishwasher is to be connected to automated
dosage of commercial detergent and rinse aid, increase the diameter of the cable and hose hole to
50 mm.
[mm]
If the dishwasher is built-in the surrounding furnishings must be resistant to any condensation from
the dishwasher.
B. Freestanding
A freestanding dishwasher must be fitted with anti-tip brackets. This comprises two brackets, which
are screwed into place as illustrated.
The dishwasher is then pushed in so that the brackets engage the rear feet. Now the dishwasher
will not topple if pressure is put on the open door. If the dishwasher is installed completely on its
own, side panels and a worktop must both be fitted. Accessories can be purchased where you
bought the dishwasher.
40
Installation
