Page 5
Customer Care Center
1-800-898-1879
www.askona.com
ASKO provides a 7/8˝ (22 mm) diameter corrugated
drain hose which is connected to the back of the unit to
form a high loop.
NOTE:
Do not use any fittings anywhere in the drain line that
are less than 7/8˝ (22 mm) OD.
The access hole for the drain line should be 1-5/8˝ (41 mm)-
2˝ (50mm) max.
The end of the drain line is 1/2˝ (12 mm), but it is
adjustable to 7/8˝, 3/4˝, 5/8˝ (22mm, 19 mm, and
16 mm). If the drain
connection is larger than
1/2˝ (12 mm), you can
easily cut the drain line to
fit the connection.
The illustrations to the right show three ways to connect
the drain supply line.
THE HIGH LOOP
The high loop is necessary for proper draining.
Therefore, all ASKO dishwashers have the drain hoses
attached to the drain pump and
fastened to the top back of the unit,
as illustrated. This gives the drain
hose an automatic high loop, which
is necessary for proper draining.
The drain hose is fastened at the
best high loop height.
To eliminate potential drain problems, simply leave this
hose in place.
DO NOT REMOVE THE HIGH LOOP ATTACHED TO THE
BACK OF THE DISHWASHER!
IMPORTANT THINGS TO REMEMBER:
•
Failure to provide the proper drain connection height
(minimum of 20" (508 mm) above the bottom of the
dishwasher base) or a 20˝ (508 mm) high loop will
result in improper drainage, which will damage the
machine.
•
No part of the drain hose should be higher than 35"
(889 mm) from the bottom of the dishwasher.
•
The drain hose can be extended to a maximum length
of 10 feet (3048 mm). Joints and jointed tubes, if any,
must have a minimum 7/8˝ (22 mm) OD.
•
If the drain line is going to be connected to a waste
disposer, be sure to remove the knockout or plug
from the fitting on the disposer before connecting the
drain line.
•
Do not use fittings smaller than 7/8˝ (22 mm) OD;
otherwise the water may not drain properly.
When the installation is ready, open the supply valve to
pressurize the fill system. Then check that all connections
are tight and there are no leaks.
THREE WAYS TO INSTALL
DRAIN CONNECTIONS
A) Typical connection to sink plumbing before trap
(high loop drain)
B) Connection to air gap then to the trap
C) Connection to waste disposer with air gap
NOTE:
Don’t forget to remove the knockout or plug from the
disposer fitting.
508
508
508
DRAIN CONNECTIONS
492161 Install DW Outdoor USA EN Rev 01.indd 5
2014-10-01 13:17:41
