ashtech HDS800, Справочное руководство

Страница: 223 / 678

207
Integrating HDS800 into Your Application
After loosening and removing the two screws from either
side of the receiver using an Allen key, remove the Ashtech
logo plate (an aluminum plate) and then the dark-blue
rubber pad.
When mounting the receiver, you do not need to put the
two lateral Ashtech logo plates and rubber pads back in
position. Not putting back these parts will not affect the
sealing of the receiver case.
If on the contrary you wish to put these parts back, be
careful with the orientation of the rubber pad. Make sure
the tab on the rubber pad goes into the receiver case (see
picture below).
Because of the thickness of the support, you will have to
use screws that are longer than those initially used to
secure the rubber pads and aluminum plates. Choose the
right length for the new screws knowing that the depth of
the tapped hole in the receiver case is 8 mm maximum.
UHF Antenna
Consider the following when you wish to use a UHF radio
system to transfer base corrections to a rover:
• As standard, each of the available radio transmitter kits is
provided with its own UHF whip antenna as well as the
coaxial cable needed to connect the transmitter to the
UHF antenna.
38 mm
135 mm 32.5 mm 32.5 mm
38 mm