ashtech HDS800, Справочное руководство

Страница: 137 / 678

121
Web Server Help Files Collection
Configuration Tab
Configuration Tab
Making Changes to
a Receiver
Configuration
Please read below the general instructions and notes about
the
Configuration
tab:
• Clicking on the
Configuration
tab causes the connected
receiver to display its current settings.
• You may have to wait a few seconds before the receiver
can respond.
• The content of the
Configuration
tab is read once on
opening each page.
• Whenever you change one or more receiver parameters in
a page, you need to click on the
Configure
button located
at the bottom of the screen to let the Web Server upload
the new parameters to the receiver.
When you click on the
Configure
button, a routine is run to
check the validity of the new parameters and a new page
opens in the Web Server. If the new parameters are valid,
the message
Successful
is displayed after all the new
parameters have effectively been uploaded to the receiver.
If some of them are not valid, the message
Failed
is
displayed, followed by the list of invalid parameters. You
then need to return to the relevant Configuration page,
correct the erroneous parameters and resume the
Configuration operation.
Note that in the receiver, any attempt to replace a
parameter (hence a valid one) with a new parameter that
is invalid will always abort (i.e. the receiver will keep the
valid parameter in its memory).
• In each of the tables presented hereafter to describe the
receiver configuration parameters, the third column
provides for reference the relevant $PASHS command,
that is the set command you could alternatively use to set
or change the described parameters.
Base Full Setup
If the receiver you are communicating with is a base or if you
want to change it into a base, click on
Base Setup
. The
following groups of parameters need to be defined:
• Base
• Antenna
• Satellites
• Internal Radio (port D)
• Serial Ports (A, B, F)