Ashford Handicrafts Limited
415 West Street, Ashburton 7700, New Zealand
Telephone 64 3 308 9087
[email protected] www.ashford.co.nz
FOOT CONTROLLER
FOR ASHFORD e-SPINNER
On/Off foot control for Ashford Electronic Spinners.
For all e-Spinners manufactured after January 2016 with a foot switch socket in the
back panel.
The e-Spinner foot switch allows you to start and stop your e-Spinner without using
your hands.
1)
Simply plug in the cord jack into the socket in the rear panel of your e-Spinner.
2)
Tap the foot controller to turn your e-Spinner on
3)
Tap the foot controller to turn your e-Spinner off
The power LED in the ON Switch shows the status of the e-Spinner.
Constant on. The e-Spinner is running OK
Flashing short on / long off. The e-Spinner is in standby, (speed set to ZERO or foot
switch OFF). Turn the power switch off if you are going to leave your e-Spinner for any
length of time.
Flashing long on / short off. The e-Spinner has a fault, (too much load or stalled motor).
Reduce the brake band tension or apply a drop of oil to the front bearing.
