Asetek InRackCDU Installation, Operation & Maintenance Guide 8
3
Tools & Materials Required
The following tools and supplies are needed to unpack and install the InRackCDU System:
Tool
Usage
Prepared by
Screwdriver with Phillips #2
to install CDU cabinet and CDM into Rack
Factory
Tin Snips
to open packing box
Factory
Box Cutter or Utility knife
to open packing box
Factory
8mm open-end wrench
to install CDM to Rack
Factory
22mm open-end wrench
to open fillcap of reservoir tank.
Service
Bucket
to make ventilation of Facility Water
Customer
Funnel(end size is 18mm or less)
to fulfill reservoir with coolant
Customer
Network Cross cable
(RJ45 to RJ45) min. 2m in length
to startup monitoring system
Service
& Customer
Laptop with wired network port
to set up network addresses in monitoring
system
Service
Server lift
to raise and install CDU cabinet into rack
Factory
Wet and Dry vacuum cleaner
to remove water on floor in case of leakage
Customer
O-ring
To replace in case of filling coolant to
reservoir tank
Customer#
Service #
# 10pcs. of O-rings are attached CDU cabinet as accessory, and customers keep them.
In case of that 10pcs. finish or customer lost, Service must be order as spare parts.
4
Unpacking the InRackCDU System
WARNING: Removing and installing the CDU Cabinet and CDM is at minimum a three-person job. The
CDU Cabinet weighs 80kg and needs to be lifted to the top U-space in the rack. It is recommended that
installers use a lift to get the cabinet into the rack
1.
The CDU Cabinet and CDMs will arrive in several boxes atop a wooden pallet packed in a cardboard
shipping carton. The weight and dimensions (LxWxH) are:
a.
HEX Cabinet:
80kg, 116cm x 75cm x 27cm (3’ 9.6” x 2’ 5.5” x 10.6”)
b.
CDM Pair (42U):
15kg, 180cm x 18cm x 16cm (5’ 10.9” x 7.1” x 6.3”)
c.
CDM Pair (48U):
17kg, 224cm x 25cm x 13cm (7’ 4.2” x 9.2” x 5.1”)
2.
Cut the strapping that holds the cardboard shipping carton to the pallet with the tin snips.
3.
Lift the cardboard carton lid off of the HEX Cabinet and CDMs and remove any packing foam inserts.
4.
Care should be taken to remove the HEX Cabinet from the crate as it weighs approximately 80kg.
Two or more people are needed to lift the HEX Cabinet vertically from its packaging.
5.
Move the HEX Cabinet and CDM clear of the pallet and set on a raised surface.
6.
Be careful not to damage the drain tube exiting the rear of the CDU Cabinet.
