Asetek InRackCDU Installation, Operation & Maintenance Guide 7
This manual is for Service, Factory and Customer. For products shipped from Fujitsu, the division
of labor described in each section is as follows.
section
division
4. Unpacking the InRackCDU System
Factory
5. Installation
5.1 Mounting the CDU Cabinet
Factory
5.2 Installing the Facility Hoses to the CDU Cabinet
Factory
5.3 Mounting the CDMs to the Rack
Factory
5.4 Connecting CDU Cabinet to CDM
Factory
5.5 Mount Ventilation Tube for Reservoir
Ventilation Tube
Service
Drain Tube
Customer
5.6 Connect Power and Networking to Monitoring System
Service
5.7 Install 3rd Party External Leak Sensors
Customer
5.8 Configure Monitoring System on Network
Default static IP address & subnet mask
Customer
Recommended Setting of Monitoring System
Customer
Status
Service
6. System Startup
Customer
7. Routine Maintenance
Service
8. Other Abnormalities and Failures #
Customer
# In case of any other Abnormalities and Failures, the CDU cabinet or CDM will be replaced,
and Service-Task will be changed to special care. Please contact your supplier.
The InRackCDU system ships out from the factory in a rack.
When the customer orders the InRackCDU system and LC Server at the same time, the water-
cooled tubes that connect the InRackCDU system and LC Server are connected by the factory.
