Asentria SiteBoss 420, Руководство пользователя

Страница: 11 / 35

Asentria SiteBoss 420 User Manual
7
Getting Connected
Power Up Sequence
When power is applied, the S420 boots up immediately. The PWR LED lights and begins to blink once every 5
seconds, and will do this continuously as a “heartbeat” while the S420 is powered on.
Default Passwords
S420 firmware version 1.00.000 did not utilize any form of password security. With version 1.00.101 a Username and
Password (basic authentication without a secure connection) are required. Default login credentials are
admin/password but these can be changed on the
Networking Settings screen.
Three attempts are allowed to enter the correct login credentials. After the third incorrect entry, the login window is no
longer displayed, leaving the user with a blank browser screen. Refresh the browser to make the login window
reappear, then try again. If needed, the default Username and Password can be set using the DIP switches as
described in the
Resetting Defaults section.
Device Status Screen
The Status tab displays the Device Status screen, which is this unit's one-stop informational source. Much of the
information that a user would need to know about the unit is available through this display. Refer to the
Status tab
section for a detailed description of all the information available on this screen.