TD 92483GB
2008-06-05/ Ver. B
Installation and Operation Manual
UPAC- Unite Packet for Messaging and Alarm
19
UPAC outputs
The UPAC hardware has two outputs of open-collector type that can be used in the Alarm
Handling. These outputs are predefined at delivery. The initial state can be set to high or
low.
Alarm Module inputs
The number of inputs that can be used can be extended by using an Alarm Module
connected to the A-bus. The input on the Alarm Module is defined by a name, the module
address
1
on the A-bus, and the input number. The states that can be detected are open
and close.
Output Module outputs
The number of outputs that can be used in UPAC can be extended by using an Output
Module connected to the A-bus. The output on the Output Module is defined by a name,
the module address
1
on the A-bus, and the output number. The initial state can be set to
high or low.
For more information refer to the hardware
,
.
4.5.2
Define Output
1
Click Other Settings > Input/Output.
2
Click “Define new output”.
3
Enter Name, A-bus Module Address and Output number.
4
Select Initial State.
5
Click “Save”.
1.Every module that is connected to the A-bus has a two digit hexadecimal address that is set with a DIP switch.
Figure 27.
