Ascension laserBIRD, Инструкция по установке и эксплуатации

Страница: 22 / 98

laserBIRD™ Installation and Operation Guide
15
15 15
15
Configuration and Basic
Operation
A method for configuring the laserBIRD is presented in this chapter, along
with a description of the basic operating characteristics.
When the laserBIRD is configured at the factory, settings are optimized to meet the needs of most
applications. However, users may find that it is helpful to customize the power-up behavior of the
laserBIRD to better meet specific application requirements.
Follow these steps to customize your system:
1.
Review the list of configurable default settings.
2.
Determine which (if any) of the settings you would like to change.
NOTE:
When two laserBIRD systems are sharing the same operating
region, you must reconfigure their default settings. See below
3.
Follow the steps in the 'Changing Your Settings ' section to run the laserBIRD Utility.
Default Configuration
The following settings are installed as power-up defaults. The laserBIRD Utility may be used to alter
this default power-up configuration. Those settings not accessible with the Utility may be changed
during normal operation, through the appropriate direct software command.
Utility Direct SW
command
BAUD RATE: 38400 #
# #
#
SCALE: 36 inches # # # # # # # #
laserBIRD ID: A
# # # #
Chapter
3