15
14
Malfunctions and Causes
Problem solving.
Problem
Check point
Procedure
The unit does
not operate.
Make sure the power cord is
correctly plugged into the
electrical outlet.
Check the circuit breakers.
Check the circuit breakers.
Make sure the fuse is not blown.
Replug the power plug into
the electric outlet.
Check the fuse of the
appliance inlet.
P5
P8
P14
P14
The unit
cannot seal
the bag, or
the bag is
not sealed
sufficiently.
Make sure the bag is
appropriate.
Make sure the bag is placed
correctly.
Make sure the foam gasket is not
deformed.
Use a bag of the proper
material or size.
Place the bag correctly.
Replace the PTFT strip.
Please contact the store where
you made the purchase.
Check the PTFT strip for wrinkles
or cracks.
Make sure the adjustment of the
sealing function is proper.
Make sure the overheating
protective device is not activated.
*If activated, the red and green
lights flash alternately.
P7
Replace the heating wire.
Restart the unit.
Set the seal time
property.
P14
Make sure the adjustment of the
sealing function is proper.
P7
P5
The sealed
part melts.
Make sure the bag is
appropriate.
Make sure there are no holes in
the PTFT strip.
Use a bag of the proper
material or size.
Set the seal time property.
Replace the PTFT strip.
P5, P7
P8
P14
The unit does
not vacuum,
or air is not
completely
removed
from the
bag.
Make sure the bag is not too
large for the volume of contents.
Make sure the bag is placed
correctly.
Check the bottom foam gasket
for cracks.
Cut or change the bag to the
appropriate size.
Place the bag properly.
Replace the PTFT strip.
Please contact the store
where you made the purchase.
Check the PTFT strip for wrinkles
or cracks.
Make sure the nozzle or the tube
for the liquid catch canister is
connected properly.
Make sure the nozzle or tube is
not clogged.
Make sure the lid of the liquid
catch canister is closed.
P11, P13
Reset the lid of the liquid
catch canister.
Clean the inside of the
nozzle or tube.
Reconnect every tube.
Care
Replacement of the PTFT Strip
Replace the PTFT strip when it is damaged and comes off.
Remove the old PTFT strip and install a
new one.
Replacement of Heating Wire
Replace the heating wire when the sealing weakens or the wire is broken.
After removing the PTFT strip, unscrew
the heating wire from the electrodes and
install a new one.
Tips
Heating wire
For surfaces where the PTFT strip
becomes soiled with oil or dust,
clean the surface and replace the
strip.
Be careful not to wrinkle the strip.
Position the strip so that it covers
the electrodes.
Setscrews are placed on both sides
of the strip.
Replace PTFT strip under the
heating wire.
Place the strip under the heating
wire to make sure that the heating
wire does not touch the unit.
The heating wire is fixed by the
electrodes. As shown in the right
illustration, adjusting the electrodes
inward with a flat head screwdriver
makes replacement easier when
installing.
Before operating the appliance unplug the power cord from the outlet.
Warning
Warning
-
-
-
-
-
-
PTFT strip
Adjust the terminals inward
with a flat head screwdriver.
Check the heater for breaks.
When setting an embossed
bag, be sure to place it with
the embossed side down.
