Page 36 / 49
11.14
Lifting of the machine
The machine is equipped with a combined lifting yoke and branch guard. For the lifting of the
machine it is important that the lifting equipment employed is approved for lifting minimum
300 kg. Place a hook or lifting strap as shown in the picture.
11.15
Description of tilt sensor
A tilt sensor is mounted at the rear end of the
machine behind the hydraulic cooler. This sensor
has two purposes:
1.
Protection of the motor. The motor is
approved and tested for driving on slopes of
maximum 58 degrees. If the motor runs at
an inclination above 58 degrees, the motor
will loose its lubrication capacity and break
down.
2.
Protection of the machine against tipping
over.
The sensor functions through a pendulum that is activating a contact. When the contact has been
active for more than 1 sec., the machine will begin
to beep, and at the same time the mower will be
disconnected.
Warning:
The sensor will not have time enough to react
before the machine tips over, if the machine runs
into a hole or skids on a slope.
Lifting eye
