Page 33 / 49
11.8
Programming of position 0
The machine is preset at the factory to stand
still when the joysticks are released.
Should this change after a time, the 0 (zero)
position can be reset through programming
the remote control.
Before this function is used, both tracks must
be lifted 5 cm above the ground with a truck
or the machine lifted in its lifting eye.
Then start the machine and set the
revolutions to 20%.
Resetting to the 0 (zero) position takes place as follows:
1.
Activate the PR [1] button for 3 sec. PR appears on the display.
2.
For adjusting the left track, move joystick [2] to the left and release it again.
3.
Then activate joystick [3] in steps. Move the joystick from position 0 and all
the way forward if the track reverses, and then release it. If the track is running
forward the joystick should be moved backwards. Repeat this in steps until the
left belt is standing still. Then press button [4] and the setting is saved.
4.
For adjusting the right track, move joystick [2]) to the right and then release it.
5.
Then joystick [3] is activated in steps. Move the joystick from position 0 and
all the way forward, if the track is reversing, and then release it. If the track is
running forward, the joystick should be moved back. Repeat this in steps until
the right track is standing still. Then press button [5], and the setting is saved.
6.
Activate the emergency stop at the remote control.
11.9
Change of frequency
If the machine’s remote control signal is
disturbed, the machine will automatically stop. In
order to continue the operation, channels must be
changed at the remote control.
This is carried out through holding button [1]
down and at the same time activate button [2].
Thereby the channel numbers are changed.
When a new channel is selected, the horn signals
with a short beep that the change is made.
The channel number appears in the display
1
.
2
.
4
.
5
.
3
.
2
1
.
