Arzel
®
Zoning Technology, Inc.
RegiDamper™ Installation Instructions
Application
The Arzel
®
RegiDamper™ is used where the branch ducts are inaccessible in finished ceilings or
in slabs, which prevent the use of the original Arzel
®
EzySlide™ dampers. The RegiDamper™ is
installed in the register boot just behind the register and is operated by a low pressure air and
vacuum pump (contained in the Arzel
®
panel) by way of a 1/4 inch plenum rated Dekoron (
UL
Rated
) tubing.
Installation Preparation
•
Remove all registers and fit damper assemblies into boots with tubing connection facing
into the duct opening (see fig. 1-a).
•
Once damper fit is verified, remove dampers from boot.
Fig 1-a: Inserting RegiDamper™
© Copyright 2004 Arzel Zoning Technology, Inc. All Rights Reserved
U.S. and Foreign Patents and Patents Pending
fig. 1-a - Fitting damper into boot
•
Cut an opening in the main trunk large enough to view the take-offs of the runs you are zoning
with RegiDampers. Locate the opening as close to the take-offs as possible. Tape the cut
edges of the opening with duct tape to prevent cutting yourself.
