Early ISC Speaker Processor
Owner's Information - all models ©2004 ARX®
Early ISC Control Unit/Speaker Processor
Information Sheet
INTERNATIONAL LIMITED WARRANTY DISCLAIMER
All these products are out of warranty. The information contained in these notes is given in good faith to
the best of our knowledge, and believed to be accurate, BUT NO GUARANTEE OF ITS ACCURACY IS
EITHER EXPRESSED OR IMPLIED. Many units may also have been modified by their owners over the
years from their original specifications, and that should be kept in mind when using these products.
You’re on your own.
!!! Check carefully at each stage for correctness of wiring and function before powering up !!!
IMPORTANT -
PLEASE READ THIS FIRST
Apart from very early units with fixed power cables, these are dual voltage
units. It is essential that you check that the voltage on the fuseholder cover
below the AC connector on the rear of the chassis is set correctly before
connecting it to AC power.
To change, pull fuseholder out and rotate 180
o
, then push in again. Do not insert
power cable into unit until voltage has been correctly set. Do not plug power
cable into AC power until voltage has been correctly set
THIS IS SET FOR 100 V AC TO
120 V AC OPERATION
THIS IS SET FOR 220 V AC TO
240 V AC OPERATION
ARX
ARX
ARX
ARX
ARX Systems Pty Ltd, PO Box 15,
Moorabbin, Victoria 3189, Australia
Phone
Phone
Phone
Phone
Phone: (03) 9555 7859 Fax
Fax
Fax
Fax
Fax: (03) 9555 6747
International Fax
International Fax
International Fax
International Fax
International Fax: +61-3 -9555 6747
On the Web
On the Web
On the Web
On the Web
On the Web: www.arx.com.au
Email: [email protected]
