|
46
Only Aruba-approved power cords may be used with Aruba devices. To access power cord information for your
switch, see
. Lost or damaged power cords must be replaced only with Aruba-approved power cords.
If your installation requires a different power cord than the one supplied with the switch and/or power supply, be
sure that the cord is adequately sized for the current requirements of the switch. In addition, be sure to use a
power cord displaying the mark of the safety agency that defines the regulations for power cords in your
country/region. The mark is your assurance that the power cord can be used safely with the switch and power
supply.
Do not use a damaged or non-recommended power cord with your switch. Using such power cords voids the switch
and power supply warranty. It can also cause serious electrical problems, including injury or death to personnel,
and damage to the switch and other property. If you cannot verify that you have a power cord approved for use
with your switch model, contact your authorized Aruba dealer or sales representative for assistance.
Remove the power cord from the switch before mounting or dismounting the switch.
Power Consumption
Switch
Power con-
sumption
Aruba CX 10000-48Y6C PrtToPwr (R8P13A)
Aruba CX 10000-48Y6C PwrToPrt (R8P14A)
Max: 780 W
Idle: TBD
n
Max power measured with maximum traffic, transceivers and fans.
n
Idle power measured with no transceivers or cables installed at room temperature.
Environmental Specifications
Port to Power airflow (PrtToPwr)
Power to Port airflow (PwrToPrt)
Operating temperature
32°F to 104°F (0°C to 40°C) (Up to 5000 ft
derate -1°C for every 1000 ft from 5000
ft to 10000 ft.)
32°F to 104°F (0°C to 40°C) (Up to 5000 ft
derate -1°C for every 1000 ft from 5000
ft to 10000 ft.)
Non-operating
temperature
-40°F to 158°F (-40°C to 70°C)
-40°F to 158°F (-40°C to 70°C)
