Installing the switch
|
18
Parts not included
If you have not already done so, order an Aruba rack mount kit for use with your 10000 switch.
Rack mounting your Aruba 10000 switch is supported using these rack mount kits:
n
Aruba CX 10000 1U 4 post Rack Mount Kit (R8R56A)
A DB9-to-RJ-45 console cable can be ordered from HPE: JL448A, Aruba X2C2 RJ45 to DB9 Console Cable.
Installation procedures for 10000 switches
1.
2.
3.
4.
Power-on the switch and check LEDs
5.
6.
7.
(optional)
8.
Connect the Switch to a Power Source
9.
Setup for Initial Configuration
Installation precautions and guidelines
To help avoid personal injury or product damage when installing your switch, read the following installation
precautions and guidelines.
n
Do not mount the switch on a wall, under a table, or under any other horizontal surface.
n
Mount devices installed in a rack or cabinet as low as possible. Put the heaviest devices at the bottom and
progressively lighter devices positioned higher.
n
To prevent the rack or cabinet from becoming unstable and/or falling over, ensure that it is adequately secured.
n
The switch may use more than one power supply cable. To fully power down the switch, you must disconnect all
power supply cables from the switch.
