Aruba 9004-MNT-19, Руководство по установке

Страница: 1 / 5

Aruba 9004-MNT-19 Kit
Installation Guide
0512128-03 | September 2019 1
This document provides installation instructions for mounting the 9004 gateway in a two-post
19-inch Telco rack. The rack mount tray supports installation of two 9004 gateway units.
Package Contents

Rack mount tray

Eight M3 x 5 mm flat head screws

Four M6 x 15 mm Phillips pan head screws

Four rubber clamps

Aruba 9004-MNT-19 Kit Installation Guide (this document, printed)
Rack Mount Installation
This mounting option allows mounting the 9004 gateway in a two-post 19-inch Telco rack.
Required Tools and Equipment
The following tools and equipment are required for installing a 9004 gateway:

Rack mount tray (x1) for rack mount installation

M3 x 5 mm flat head screws (x8) for securing the gateway on the rack mount tray

M6 x 15 mm Phillips pan head screws (x4) for rack mount

Suitable screwdrivers for all screw types provided in the box (not included in the kit)
Installation Steps
To install a 9004 gateway into a two post 19-inch rack:
1. Align the 9004 gateway to the screw hole provided on the rack mount tray.
2. Align the screws under the rack mount tray and tighten the screws to secure the 9004 gateway on
the rack mount tray. See Figure 1 .
Some racks require screws that differ from those included with the 9004 gateway accessory kit. Ensure that
you have the correct screws before installing the 9004 gateway.
Ensure that the front panel of the 9004 gateway is facing towards the front side of the rack mount tray.