Aruba 800-E, Руководство по установке

Страница: 43 / 52

Aruba 800-E 35
Installation Guide
Ports
Appendix A
Each FE port has its own POE LED, located at the right side of the port. This
LED provides the following POE status information:
Pin Outs
The RJ-45 female connector pin-outs are shown in Figure A-2 :
F
IGURE
A-2 FE Network Port Pin-outs
Cables
The type of cable required for each port depends on the device being connected:
„
Direct connection to a SPOE compatible device
This requires an 8-conductor Category 5 UTP Ethernet cable with an RJ-45
male connector. A straight-through cable is required to preserve POE voltage
polarity.
The port should be connected to the intended device either directly or using a
SPOE adapter with no intervening hubs, routers, switches, or other network
equipment.
Aruba SPOE adapters separate the serial and FE portions of the cable and
route them to their individual ports on the connected device. There are two
adapter models:
T
ABLE
A-2 FE POE LED
Status Description
Off The port is disabled or the attached device has not
requested power. POE is not being provided by the port.
Green POE is being provided to the attached device.
Amber The attached device has requested power, but POE is not
being provided by the port.
LNK/
ACT
POE
1
2
3
4
5
6
7
8
RJ-45 Female
Pin-Out
**Serial optional
*POE optional
Direction
Input
Output
10/100 Mbps
Ethernet
Serial TxD ** (POE positive*)
Serial TGND ** (POE positive*)
Serial RxD ** (POE negative*)
Serial RGND ** (POE negative*)
1
2
3
4
5
6
7
8 ETH Rx+ (POE negative*)
ETH Rx– (POE negative*)
ETH Tx+ (POE positive*)
ETH Tx– (POE positive*)