Aruba 800-E, Руководство по установке

Страница: 15 / 52

Aruba 800-E 7
Installation Guide
Installing the Chassis
Chapter 2
Rack Mounting Kit
Using the included rack mounting kit, you can mount the 800-E Access
Multiplexer in a standard 19-inch network equipment rack. The rack mounting kit
contains the following parts:
F
IGURE
2-1 Rack Mounting Kit
N
OTE
: The four 12-24 screws are intended for securing the switch to the rack.
Some racks require different screws which are not included. Make sure
that you have the correct screws or fasteners for your rack system before
attempting to mount the switch.
Selecting a Location
The 800-E Access Multiplexer, like other network and computing devices,
requires an “electronics friendly” environment.
Reliable power
Make sure that your electrical outlet is compatible with the 800-E Access
Multiplexer. The switch power input is auto-ranging and accepts
90~132/180~264 VAC, 50 to 60 Hz, 3.5/2.0 A.
The power cords must be rated to 10 A and conform to grounded electrical
standards in the country where the product is operated.
Use of a power line conditioner or Uninterruptible Power Supply (UPS) can
decrease or mitigate problems caused by power service fluctuations. Make
sure that the output of any power shaping device is compatible with the
800-E Access Multiplexer power supply.
Cool, non-condensing ventilation
For proper operation, the 800-E Access Multiplexer requires an environment
with an ambient air temperature between 0 to 40 ºC (32 to 104 ºF). Humidity
must be kept at non-condensing levels between 5 and 95%.
x 4
Left
Bracket
Right
Bracket
x 6
6-32 Flat Head
Screws
12-24 Screws