Aruba 580EX Series Hazardous Location Outdoor Access Points
| Installation Guide
9
Figure 7
Fiber-optic Cable and CKIT-EX-OD-SFP SFP Gland Kit
To connect the fiber-optic cable to the access point, perform the following steps.
1. Remove the dust cap from the E1 SFP+ port.
2. Insert the transceiver module into the SFP+ port, and ensure it is in place.
3. Slide the sealing nut, seal A, seal B, gland body, O-ring and SFP extension tube over the fiber-optic cable.
4. Insert the connector of the fiber-optic cable into the transceiver module, and ensure the connector is firmly
in place.
5. Screw the SFP extension tube into the E1 SFP+ port and tighten to a torque of 88 in/lbs (10 Nm).
6. Place the O-ring on the gland body, and ensure it is in place.
7. Thread the gland body into the SFP extension tube and tighten to a torque of 70.5 in/lbs (8 Nm).
8. Push the seal B and seal A into the gland body and tighten the sealing nut onto the gland body to a torque of
53in/lbs (6 Nm).
Fiber-optic Cable
O-ring
Gland Body
Seal B
Seal A
Sealing Nut
SFP Extension Tube
