Aruba 4100i Switch Series | Installation and Getting Started Guide
37
n
JL818A
2. Use a Phillips screwdriver to remove the ground screw from the switch. Save the screws for later use.
3. Crimp and strip 7mm of the grounding wire.
4. Insert the grounding wire into the ring terminal lug, then crimp the terminal to the wire.
5. Slide the ground screw through the terminal.
6. Insert the ground screw into the functional ground screw opening on the front panel.
7. Use a ratcheting torque screwdriver to tighten the ground screws and ring terminal to the switch
front panel. The torque should not exceed 6 kg-cm (5.2 lb-in).
8. Attach the other end of the ground wire to an appropriate ground, such as a ground bus, a grounded
DIN rail, or a grounded bare rack.
Installation Procedures for 12-port JL817A Switches
