Aruba 387 Series Скачать руководство пользователя страница 8

8

Aruba 387 Series Outdoor Access Points

| Installation Guide

Storage

Temperature: -40ºC to 70ºC (-40ºF to 158ºF)

Humidity: 5% to 93% non-condensing

For additional specifications on this product, please refer to the data sheet at 

www.arubanetworks.com

.

Regulatory Model Number

The regulatory model number (RMN) for 387 Series:

AP-387: APEX0387

Safety and Regulatory Compliance

FCC

To view the FCC ID for controller-managed access points:
1. Log into the controller WebUI
2. Navigate to Maintenance > Controller > About
To view the FCC ID for Instant access points:
1. Log into the virtual controller WebUI
2. Navigate to Maintenance > About

FCC Class B Part 15

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not 

installed and used in accordance with the manufacturer’s instructions, may cause harmful interference to radio 

communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be determined by turning the equipment 

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

!

CAUTION

RF Radiation Exposure Statement:

 This equipment complies with RF radiation exposure limits. This 

equipment should be installed and operated with a minimum distance of 14.96 inches (38cm) between the 
radiator and your body for 2.4GHz, 5GHz and 60GHz operations.

!

CAUTION

Déclaration de la concernant l’exposition aux rayonnements à fréquence radioélectrique (FR):

 Cet 

appareil est conforme aux limites d’exposition aux rayonnements FR établies. Il doit être installé et utilisé à une 
distance minimale de 38 cm (14.96 pouces) entre le radiateur et votre corps, qu’il opère sur la bande 2.4 GHz, 
5GHz ou 60GHz.

!

CAUTION

The device could automatically discontinue transmission in case of absence of information to transmit, or 
operational failure. Note that this is not intended to prohibit transmission of control or signaling information 
or the use of repetitive codes where required by the technology.

!

CAUTION

Changes or modifications to this unit not expressly approved by the party responsible for compliance could 
void the user’s authority to operate this equipment.

!

CAUTION

Toute modification effectuée sur cet équipement sans l'autorisation expresse de la partie responsable de la 
conformité est susceptible d'annuler son droit d'utilisation.

Содержание 387 Series













Отзывы: