Aruba Networks AP-500H-MNTD, Руководство по установке

Страница: 1 / 2

AP-500H-MNTD Mount Kit
Installation Guide
0512149-01 | May 2020 1
The AP-500H-MNTD is a stand-alone desk mount for the 500H access points.
Package Contents

Mount stand

(x2) M2.5x12, T8H Hex screws

(x2) M2.5x12 Pan Head Phillips screws

(x1) M2.5x7 T8H Hex Plastite screw
Installation
1. Attach an active Ethernet cable to the E0 port located on the back of the access point, as shown in Figure 1 .
2. Align the slots on the back of the access point against the guide posts and slots on the mount, then slide the
access point down, as shown in Figure 1 .
Figure 1 Install Access Point to Mount Cover
3. Once the access point is attached to the desk mount, insert and fasten the security screw on the right side of
the mount, as shown in Figure 2 .
4. Insert either the two M2.5x12 or T8H Hex security screws into the holes on the back of the mount stand and
tighten to anchor the access point to the mount, as shown in Figure 2 .
A #1 Phillips and T8H screwdriver are required for installation.
This mount kit only supports the desktop solution for the 500H Series access points.